- 14 Jun, 2008 40 commits
-
-
Harvey Harrison authored
Many callers already expect it to. Signed-off-by:
Harvey Harrison <harvey.harrison@gmail.com> Signed-off-by:
John W. Linville <linville@tuxdriver.com>
-
Harvey Harrison authored
Replaced by the new helper ieee80211_has_morefrags which is more consistent with the intent of the function. Signed-off-by:
-
Harvey Harrison authored
A few general categories: 1) ieee80211_has_* tests if particular fctl bits are set, the helpers are de in the same order as the fctl defines: A combined _has_a4 was also added to test when both FROMDS and TODS are set. 2) ieee80211_is_* is meant to test whether the frame control is of a certain ftype - data, mgmt, ctl, and two special helpers _is_data_qos, _is_data_pres which also test a subset of the stype space. When testing for a particular stype applicable only to one ftype, functions like ieee80211_is_ack have been added. Note that the ftype is also being checked in these helpers. They have been added for all mgmt and ctl stypes in the same order as the STYPE defines. 3) ieee80211_get_* is meant to take a struct ieee80211_hdr * and returns a pointer to somewhere in the struct, see get_SA, get_DA, get_qos_ctl. The intel wireless drivers had helpers that used this namespace, convert the all to use the new helpers and remove the byteshifting as they were defined in cpu-order rather than little-endian. Signed-off-by:
-
Jouni Malinen authored
Use a shared function for transmitting the frames instead of duplicated code in two places. Signed-off-by:
Jouni Malinen <j@w1.fi> Signed-off-by:
-
Jouni Malinen authored
Remove unnecessary '__constant_' prefix and use the atomic version of ieee80211_iterate_active_interfaces(). Signed-off-by:
-
Jouni Malinen authored
Clean up the introduction and fix a typo. Signed-off-by:
-
Jouni Malinen authored
mac80211_hwsim is a Linux kernel module that can be used to simulate arbitrary number of IEEE 802.11 radios for mac80211 on a single device. It can be used to test most of the mac80211 functionality and user space tools (e.g., hostapd and wpa_supplicant) in a way that matches very closely with the normal case of using real WLAN hardware. From the mac80211 view point, mac80211_hwsim is yet another hardware driver, i.e., no changes to mac80211 are needed to use this testing tool. Signed-off-by:
Johannes Berg <johannes@sipsolutions.net> Signed-off-by:
-
Emmanuel Grumbach authored
This patch unifies SW rf-kill flow between 4965 and 5000. It enables SW RF-kill for 5000. This patch also solves a bug in iwl4965_mac_config: bad mutex locking balance. Signed-off-by:
Emmanuel Grumbach <emmanuel.grumbach@intel.com> Signed-off-by:
Tomas Winkler <tomas.winkler@intel.com> Signed-off-by:
Zhu Yi <yi.zhu@intel.com> Signed-off-by:
-
Ron Rindjunsky authored
The patch removes 4965 prefix from iwl4965_ucode. Signed-off-by:
Ron Rindjunsky <ron.rindjunsky@intel.com> Signed-off-by:
-
Ester Kummer authored
This patch returns channel list to sysfs. Signed-off-by:
Ester Kummer <ester.kummer@intel.com> Signed-off-by:
-
Tomas Winkler authored
This patch fixes setting beacon interval 1. in register_hw it honors value requested by the driver 2. It uses default 100 instead of 1000 or 10000. Scanning for beacon interval ~1sec and above is not sane Signed-off-by:
-
Robert P. J. Day authored
Signed-off-by:
Robert P. J. Day <rpjday@crashcourse.ca> Signed-off-by:
-
Jussi Kivilinna authored
Reduce amount of kmalloc/kfree calls in set/get_oid by preallocating command buffer. Signed-off-by:
Jussi Kivilinna <jussi.kivilinna@mbnet.fi> Signed-off-by:
-
Jussi Kivilinna authored
rndis_wlan used kmalloc to allocate private data structure and leaving data uninitialized, but later assumed to be set zero. Signed-off-by:
-
Ron Rindjunsky authored
This patch denies the use of framentation while ampdu is used. Signed-off-by:
-
Emmanuel Grumbach authored
This patch removes the iwlcore_low_level_notify. The notification chain is not required in this level. Signed-off-by:
-
Emmanuel Grumbach authored
This patch cleans up iwlwifi's code: Add missing include, remove empty lines etc... Signed-off-by:
-
Zhu Yi authored
The patch fixes the problem that software rf_kill messes up the card status when it is disabled if the interface is down. Signed-off-by:
-
Emmanuel Grumbach authored
This patch removes iwl4965_calc_db_from_ratio which is dead code. Signed-off-by:
-
Emmanuel Grumbach authored
This patch renames iwl4965_get_tempearture to iwl4965_hw_get_temperature and replaces usage of original iwl4965_hw_get_temperature by direct access to priv->temperature. Signed-off-by:
-
Emmanuel Grumbach authored
This patch moves iwl4965_rf_kill_ct_config to iwl-core.c. Signed-off-by:
-
Tomas Winkler authored
This patch 1. cleans up scanning code. 2. It adds round robin of TX antannas/chains. Signed-off-by:
-
Tomas Winkler authored
This patch moves rate helpers to iwlcore. Signed-off-by:
-
Tomas Winkler authored
This patch moves scan code to iwl-scan.c file in iwlcore module. Signed-off-by:
-
Emmanuel Grumbach authored
This patch adds a check for bad length in set key flow. This solves the Oops reported by Thomas Backlund, Joonwoo Park and Ian Schram. It also adds some debug printing that can be useful. Signed-off-by:
-
Tomas Winkler authored
This patch 1. Refactors settings of tx power 2. enables iwconfig txpower <value> 3. adds 5000 HW tx power Signed-off-by:
-
Tomas Winkler authored
This patch refactors tx aggregation respnse flow and fixes bug revealed by tx_info to cb patch Signed-off-by:
-
Assaf Krauss authored
This fix allows to move between modes (ad-hoc to managed, and vice versa). Since mode changes can only be done while driver is down, check for ibss support can only be made when the channel is set (afte the driver goes up). Signed-off-by:
Assaf Krauss <assaf.krauss@intel.com> Signed-off-by:
-
Assaf Krauss authored
This patch enables ibss mode. It consists of two changes upon entering ibss mode: 1. Removing the redundant line which clears the driver's station table. This line creates a discrepancy between the driver and the FW's station table. This prevented the generation of beacons. 2. Assigning a default value to priv's assoc_id. Normally given by an AP in STA mode, this field is used as an indication for association. Being 0, it prevented normal TX flow. 3. Remove a redundant ADD_STA command that cause uCode error. 4. Delay the set_mode until after the uCode is ready. Signed-off-by:
-
Emmanuel Grumbach authored
Clear STATUS_FW_ERROR in the _up_ flow before reseting NIC. UP flow will otherwise call restart again causing endless restart loop. Signed-off-by:
-
Mohamed Abbas authored
This patch fixes SW RF-kill. If we resumed from S3 state with SW RF-kill set, the driver wouldn't be able to remove SW RF-kill. This patch fixes this. Signed-off-by:
Mohamed Abbas <mabbas@linux.intel.com> Signed-off-by:
-
Tomas Winkler authored
This patch changes uCode log print to for easier parsing. Signed-off-by:
-
Emmanuel Grumbach authored
It is wrong to set the rxon channel according to the ht-channel in case there is a mismatch (e.g. when there is no ht). Signed-off-by:
Guy Cohen <guy.cohen@intel.com> Signed-off-by:
-
Emmanuel Grumbach authored
This patch removes redundant flags regarding to FAT channel. Use mac80211's flag instead. Signed-off-by:
-
Tomas Winkler authored
This patch removes IEEE80211_CHAN_W_RADAR_DETECT flag. Signed-off-by:
-
Ron Rindjunsky authored
This fix opens back the aggregation decision path for iwlwifi. Signed-off-by:
-
Ron Rindjunsky authored
This patch switches the use of internal iwlwifi structure with ieee80211_conf in order to examine ht rate capabilities. Signed-off-by:
-
Tomas Winkler authored
This patch adds TX aggregation handler for 5000 HW. Signed-off-by:
-
Ron Rindjunsky authored
This patch maps sw and hw queues (for aggregations), so the right mac80211 queue will be waken when ieee80211_wake_queue is invoked. Signed-off-by:
-
Emmanuel Grumbach authored
This patch adds the possibility to disable the tx_power calibration. In 5000 HW, this calibration is implemented in uCode, hence, it is disabled in driver by default. Signed-off-by:
-
