Skip to content

L
linux-davinci
Switch branch/tag
  1. 31 Jul, 2009 1 commit
  3. 30 Jul, 2009 1 commit
  5. 29 Jul, 2009 3 commits
  7. 28 Jul, 2009 3 commits
  9. 24 Jul, 2009 2 commits
  11. 23 Jul, 2009 6 commits
    • Marek Vasut's avatar
      ALSA: Allow passing platform_data to devices attached to AC97 bus · 474828a4
      Marek Vasut authored 
      This patch allows passing platform_data to devices attached to AC97 bus
(like touchscreens, battery measurement chips ...).
Signed-off-by: default avatarMarek Vasut <marek.vasut@gmail.com>
Signed-off-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
      474828a4
    • Joonyoung Shim's avatar
      ASoC: MAX9877: fix write operation for register · a7569afa
      Joonyoung Shim authored 
      The MAX9877 needs an address of start register when we write values to
registers through i2c_master_send(), but the code for this was missed in
max9877_write_regs().

If the value of control is 0 in the max9877_set_out_mode(), the value is
not increased to 1, but actually the value to write to the register
should be 1.
And the register bits for out_mode and osc_mode should be cleared before
writing.
Signed-off-by: default avatarJoonyoung Shim <jy0922.shim@samsung.com>
Signed-off-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
      a7569afa
    • Janusz Krzysztofik's avatar
      ASoC: Add support for Conexant CX20442-11 voice modem codec · 459dc352
      Janusz Krzysztofik authored 
      This patch adds support for Conexant CX20442-11 voice modem codec, suitable
for use by the ASoC board driver for Amstrad E3 (Delta) videophone. Related
sound card driver will follow.

This codec is an optional part of the Conexant SmartV three chip modem design.
As such, documentation for its proprietary digital audio interface is not
available. However, on Amstrad Delta board, thanks to Mark Underwood who
created an initial, omap-alsa based sound driver a few years ago[1], the codec
has been discovered to be accessible not only from the modem side, but also
over the OMAP McBSP based CPU DAI. Thus, the driver can be used by any sound
card that can access the codec DAI directly. The DAI configuration parameters
(sample rate and format, number of channels) has been selected out empirically
for best user experience.

The codec analogue interface consists of two pairs of analogue I/O pins:
speakerphone interface or telephone handset/headset interface. Furthermore, it
seams to provide two operation modes for speakerphone I/O: standard and
advanced, with automatic gain control and echo cancelation. Even if the codec
control interface is unknown and not available, all those interfaces and modes
can be selected over the modem chip using V.253 commands. The driver is able
to issue necessary commands over a suitable hw_write function if provided by a
sound card driver. Otherwise, the codec can be controlled over the modem from
userspace while inactive.

Even if nothig is known about the codec internal power management
capabilities, DAPM widgets has been used to model the codec audio map.
Automatically performed powering up/down of those virtual widgets results in
corresponding V.253 commands being issued.

Some driver features/oddities may be board specific, but I have no way to
verify that with any board other than Amstrad Delta.

[1] http://www.earth.li/pipermail/e3-hacking/2006-April/000481.html

Created and tested against linux-2.6.31-rc3.
Applies and works with linux-omap-2.6 commit
7c5cb7862d32cb344be7831d466535d5255e35ac as well.
Signed-off-by: default avatarJanusz Krzysztofik <jkrzyszt@tis.icnet.pl>
Signed-off-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
      459dc352
    • Mark Brown's avatar
      Merge branch 'for-2.6.31' into for-2.6.32 · c30853df
      Mark Brown authored
      c30853df
    • Lopez Cruz, Misael's avatar
      ASoC: OMAP: Staticise pcm creation function of omap-pcm · d756b277
      Lopez Cruz, Misael authored 
      Signed-off-by: default avatarMisael Lopez Cruz <x0052729@ti.com>
Signed-off-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
      d756b277
    • Chaithrika U S's avatar
      ASoC: tlv320aic3x: Enable PLL when not bypassed · 06c71282
      Chaithrika U S authored 
      PLL was not being enabled when it was not bypassed. This patch
enables the PLL when it is used. Additionally, it disables the PLL
when it is bypassed.

Without this patch, the audio on TI DM646x EVM and DM355 EVM
does not work properly. The bit clocks and the frame sync signals
from the codec are not correct and hence the playback/record are faster
than usual for most sample rates. The reason for this was that the PLL
was not enabled when it was not bypassed.

Tested on DM6467 EVM, playback tested on DM355 EVM.
Signed-off-by: default avatarChaithrika U S <chaithrika@ti.com>
Signed-off-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
      06c71282
  13. 22 Jul, 2009 1 commit
  15. 21 Jul, 2009 1 commit
  17. 18 Jul, 2009 1 commit
  19. 17 Jul, 2009 4 commits
  21. 16 Jul, 2009 2 commits
  23. 15 Jul, 2009 5 commits
  25. 14 Jul, 2009 2 commits
  27. 13 Jul, 2009 6 commits
  29. 09 Jul, 2009 2 commits