- 24 Apr, 2008 40 commits
-
-
Frej Drejhammar authored
The cx2388x family has support for chroma AGC. This patch implements a the V4L2_CID_CHROMA_AGC control for the cx2388x family. By default chroma AGC is disabled, as in previous versions of the driver. Signed-off-by: "Frej Drejhammar <frej.drejhammar@gmail.com>" Signed-off-by:Mauro Carvalho Chehab <mchehab@infradead.org>
-
Frej Drejhammar authored
Define a pre-defined control ID for chroma automatic gain control. Signed-off-by: "Frej Drejhammar <frej.drejhammar@gmail.com>" Signed-off-by: -
Marton Balint authored
If the IR worker is not stopped before the removal of the cx88xx module, an OOPS may occur, because the worker function cx88_ir_work gets called. So stop the ir worker. Signed-off-by:
Marton Balint <cus@fazekas.hu> Signed-off-by:
-
Mauro Carvalho Chehab authored
This board has a s5h1409 demod, plus a xc30x8 tuner (probably, xc3018). This patch adds proper support for radio, video, s-video, composite and ATSC. However, support for radio and video depends on having s5h1409 i2c gate open, otherwise, xc30x8 chip won't be visible. For a better support, some rework is needed on cx88 driver, to allow adding xc30x8 to i2c bus without sending i2c 0 byte reading to 0xc2 address. Thanks to Vanessa Ezekowitz <vanessaezekowitz@gmail.com> for helping to figure out the proper parameters for s5h1409 and the GPIO pins used by each configuration. Signed-off-by: -
Mike Isely authored
Fix use of a non-int (size_t) being passed in a printf width field. This benign issue has apparently been around for a long time, but went undetected until now. Signed-off-by:
Mike Isely <isely@pobox.com> Signed-off-by:
-
Michael Krufky authored
Update Kconfig for the hybrid devices recently converted to use tuner-simple rather than dvb-pll. dvb-bt8xx no longer uses dvb-pll at all, so remove all references to dvb-pll within that driver. Signed-off-by:
Michael Krufky <mkrufky@linuxtv.org> Signed-off-by:
-
Michael Krufky authored
Fix the following build error: In file included from dvb-bt8xx.c:35: dvb-bt8xx.h:42:26: error: tuner-simple.h: No such file or directory dvb-bt8xx.c: In function 'frontend_init': dvb-bt8xx.c:612: error: 'simple_tuner_attach' undeclared (first use in this function) dvb-bt8xx.c:612: error: (Each undeclared identifier is reported only once dvb-bt8xx.c:612: error: for each function it appears in.) dvb-bt8xx.c:612: warning: type defaults to 'int' in declaration of '__a' dvb-bt8xx.c:612: warning: type defaults to 'int' in declaration of 'type name' dvb-bt8xx.c:612: warning: cast from pointer to integer of different size dvb-bt8xx.c:612: warning: type defaults to 'int' in declaration of 'type name' dvb-bt8xx.c:612: warning: cast from pointer to integer of different size dvb-bt8xx.c:612: error: called object '__a' is not a function dvb-bt8xx.c:696: warning: type defaults to 'int' in declaration of '__a' dvb-bt8xx.c:696: warning: type defaults to 'int' in declaration of 'type name' dvb-bt8xx.c:696: warning: cast from pointer to integer of different size dvb-bt8xx.c:696: warning: type defaults to 'int' in declaration of 'type name' dvb-bt8xx.c:696: warning: cast from pointer to integer of different size dvb-bt8xx.c:696: error: called object '__a' is not a function Signed-off-by:
-
Mauro Carvalho Chehab authored
There are a number of different firmware versions and variants, shipped together with boards. This patch adds an extra parameter to the tuner-xc2028 to allow specifying for an specific firmware name to be loaded. This helps to test for a firmware that better fits some board. Signed-off-by: -
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
Force the main pll charge pump or cal pll charge pump to source current to the main pll loop filter or cal pll loop filter, respectively. Signed-off-by:
-
Michael Krufky authored
Set rfagc to high speed mode before setting the pll. Set rfagc to normal speed mode at the end of the function. Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
allow device-specific configuration of rf agc rf top and if top Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
The internal calibration signal must be set on the cal pll. Signed-off-by:
-
Michael Krufky authored
Both the tda18271 c1 and c2 parts only need EP3 through MD3 to be written for the image rejection calibration's low band initialization. Signed-off-by:
-
Michael Krufky authored
The ability to select RF input was a supported feature only available on Philips TUV1236d and Philips FCV1236d. This feature, along with support for the tuners that used it, was moved into the tuner-simple module. This can now be removed from dvb-pll. Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
remove #if 0'd support for: Philips TUV1236D Philips TD1316 Philips FMD1216ME LG TDVS-H06xF Philips FCV1236D Thomson FE6600 Microtune 4042 FI5 Thomson dtt761x Support for these tuners has been moved into the 'tuner-simple' module. Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
Convert cx88-dvb and saa7134-dvb to use tuner-simple instead of dvb-pll for Philips TUV1236D Signed-off-by:
-
Michael Krufky authored
Convert saa7134-dvb to use tuner-simple instead of dvb-pll for Philips TD1316 Signed-off-by:
-
Michael Krufky authored
Convert cxusb, cx88-dvb and saa7134-dvb to use tuner-simple instead of dvb-pll for Philips FMD1216ME Signed-off-by:
-
Michael Krufky authored
Convert cx88-dvb, dvb-bt8xx, b2c2-flexcop, cxusb and cx23885 to use tuner-simple instead of dvb-pll for LG TDVS-H06xF Signed-off-by:
-
Michael Krufky authored
Convert dvb-bt8xx to use tuner-simple instead of dvb-pll for Philips FCV1236D Signed-off-by:
-
Michael Krufky authored
Convert cx88-dvb to use tuner-simple instead of dvb-pll for Thomson FE6600 Signed-off-by:
-
Michael Krufky authored
Convert cx88-dvb to use tuner-simple instead of dvb-pll for Microtune 4042 FI5 Signed-off-by:
-
Michael Krufky authored
Convert cx88-dvb to use tuner-simple instead of dvb-pll for Thomson DTT 761X Signed-off-by:
-
Michael Krufky authored
Add module options to tuner-simple, called "atv_input" and "dtv_input" to specify which rf input to use on devices with multiple rf inputs. If the module option is not specified, then the driver will autoselect the rf input, as per previous behavior. Signed-off-by:
-
Guennadi Liakhovetski authored
In case of muliple cameras, handled by the same driver, they can support Signed-off-by: -
Douglas Schilling Landgraf authored
Removed unnecessary VIDIOC_G_PRIORITY validation. Signed-off-by:
Douglas Schilling Landgraf <dougsland@gmail.com> Signed-off-by:
-
