Commit eda79a30 authored by Adrian Hunter's avatar Adrian Hunter Committed by Liam Girdwood

regulator: Add 'start-up time' to fixed voltage regulators

Add a field to specify a delay for the start-up time of
a fixed voltage regulator.
Signed-off-by: default avatarAdrian Hunter <adrian.hunter@nokia.com>
Acked-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: default avatarLiam Girdwood <lrg@slimlogic.co.uk>
parent 75c8ac22
......@@ -24,12 +24,14 @@
#include <linux/regulator/driver.h>
#include <linux/regulator/fixed.h>
#include <linux/gpio.h>
#include <linux/delay.h>
struct fixed_voltage_data {
struct regulator_desc desc;
struct regulator_dev *dev;
int microvolts;
int gpio;
unsigned startup_delay;
unsigned enable_high:1;
unsigned is_enabled:1;
};
......@@ -48,6 +50,8 @@ static int fixed_voltage_enable(struct regulator_dev *dev)
if (gpio_is_valid(data->gpio)) {
gpio_set_value_cansleep(data->gpio, data->enable_high);
data->is_enabled = 1;
if (data->startup_delay)
udelay(data->startup_delay);
}
return 0;
......@@ -117,6 +121,7 @@ static int regulator_fixed_voltage_probe(struct platform_device *pdev)
drvdata->microvolts = config->microvolts;
drvdata->gpio = config->gpio;
drvdata->startup_delay = config->startup_delay;
if (gpio_is_valid(config->gpio)) {
drvdata->enable_high = config->enable_high;
......
......@@ -25,6 +25,7 @@ struct regulator_init_data;
* @microvolts: Output voltage of regulator
* @gpio: GPIO to use for enable control
* set to -EINVAL if not used
* @startup_delay: Start-up time in microseconds
* @enable_high: Polarity of enable GPIO
* 1 = Active high, 0 = Active low
* @enabled_at_boot: Whether regulator has been enabled at
......@@ -41,6 +42,7 @@ struct fixed_voltage_config {
const char *supply_name;
int microvolts;
int gpio;
unsigned startup_delay;
unsigned enable_high:1;
unsigned enabled_at_boot:1;
struct regulator_init_data *init_data;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment