Add support to disconnect the pull-up resistor on CD/DAT[3] (pin 1)

of the card. This may be desired on certain setups of boards,
controllers and embedded sdio devices which do not need the card's
pull-up. As a result, card detection is disabled and power is saved.
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Acked-by: Matt Fleming <matt@console-pimps.org>
Cc: Ian Molton <ian@mnementh.co.uk>
Cc: "Roberto A. Foglietta" <roberto.foglietta@gmail.com>
Cc: Philip Langdale <philipl@overt.org>
Cc: Pierre Ossman <pierre@ossman.eu>
Cc: David Vrabel <david.vrabel@csr.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>

drivers/mmc/core/sdio.c

@@ -164,6 +164,33 @@ static int sdio_enable_wide(struct mmc_card *card)
 	return 0;
 }
 
+/*
+ * If desired, disconnect the pull-up resistor on CD/DAT[3] (pin 1)
+ * of the card. This may be required on certain setups of boards,
+ * controllers and embedded sdio device which do not need the card's
+ * pull-up. As a result, card detection is disabled and power is saved.
+ */
+static int sdio_disable_cd(struct mmc_card *card)
+{
+	int ret;
+	u8 ctrl;
+
+	if (!card->cccr.disable_cd)
+		return 0;
+
+	ret = mmc_io_rw_direct(card, 0, 0, SDIO_CCCR_IF, 0, &ctrl);
+	if (ret)
+		return ret;
+
+	ctrl |= SDIO_BUS_CD_DISABLE;
+
+	ret = mmc_io_rw_direct(card, 1, 0, SDIO_CCCR_IF, ctrl, NULL);
+	if (ret)
+		return ret;
+
+	return 0;
+}
+
 /*
  * Test if the card supports high-speed mode and, if so, switch to it.
  */
@@ -384,6 +411,13 @@ int mmc_attach_sdio(struct mmc_host *host, u32 ocr)
 	if (err)
 		goto remove;
 
+	/*
+	 * If needed, disconnect card detection pull-up resistor.
+	 */
+	err = sdio_disable_cd(card);
+	if (err)
+		goto remove;
+
 	/*
 	 * Initialize (but don't add) all present functions.
 	 */

include/linux/mmc/card.h

@@ -64,7 +64,8 @@ struct sdio_cccr {
 				low_speed:1,
 				wide_bus:1,
 				high_power:1,
-				high_speed:1;
+				high_speed:1,
+				disable_cd:1;
 };
 
 struct sdio_cis {