[POWERPC] Don't shutdown TX on mpc5200 serial port if it is a console

If the serial port gets shut down, then console output stalls.  9 out
of 10 kernel hackers agree, this is a bad thing.
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
Signed-off-by: Sylvain Munaut <tnt@246tNt.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

drivers/serial/mpc52xx_uart.c

@@ -257,9 +257,10 @@ mpc52xx_uart_shutdown(struct uart_port *port)
 {
 	struct mpc52xx_psc __iomem *psc = PSC(port);
 
-	/* Shut down the port, interrupt and all */
+	/* Shut down the port.  Leave TX active if on a console port */
 	out_8(&psc->command,MPC52xx_PSC_RST_RX);
-	out_8(&psc->command,MPC52xx_PSC_RST_TX);
+	if (!uart_console(port))
+		out_8(&psc->command,MPC52xx_PSC_RST_TX);
 
 	port->read_status_mask = 0;
 	out_be16(&psc->mpc52xx_psc_imr,port->read_status_mask);