mmc_block: wait for card even on failures

Many failures are non-permanent, but the card might need some time to
finish what it is doing before becoming responsive again. Make sure we
wait for it to finish programming before dealing with the error.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>

drivers/mmc/card/block.c

@@ -2,7 +2,7 @@
  * Block driver for media (i.e., flash cards)
  *
  * Copyright 2002 Hewlett-Packard Company
- * Copyright 2005-2007 Pierre Ossman
+ * Copyright 2005-2008 Pierre Ossman
  *
  * Use consistent with the GNU GPL is permitted,
  * provided that this copyright notice is
@@ -296,22 +296,24 @@ static int mmc_blk_issue_rq(struct mmc_queue *mq, struct request *req)
 
 		mmc_queue_bounce_post(mq);
 
+		/*
+		 * Check for errors here, but don't jump to cmd_err
+		 * until later as we need to wait for the card to leave
+		 * programming mode even when things go wrong.
+		 */
 		if (brq.cmd.error) {
 			printk(KERN_ERR "%s: error %d sending read/write command\n",
 			       req->rq_disk->disk_name, brq.cmd.error);
-			goto cmd_err;
 		}
 
 		if (brq.data.error) {
 			printk(KERN_ERR "%s: error %d transferring data\n",
 			       req->rq_disk->disk_name, brq.data.error);
-			goto cmd_err;
 		}
 
 		if (brq.stop.error) {
 			printk(KERN_ERR "%s: error %d sending stop command\n",
 			       req->rq_disk->disk_name, brq.stop.error);
-			goto cmd_err;
 		}
 
 		if (!mmc_host_is_spi(card->host) && rq_data_dir(req) != READ) {
@@ -344,6 +346,9 @@ static int mmc_blk_issue_rq(struct mmc_queue *mq, struct request *req)
 #endif
 		}
 
+		if (brq.cmd.error || brq.data.error || brq.stop.error)
+			goto cmd_err;
+
 		/*
 		 * A block was successfully transferred.
 		 */