Commit 5e682ef8 authored by Kevin Hilman's avatar Kevin Hilman

Revert "rtc: omap: let device wakeup capability be configured from chip init logic"

This reverts commit 9c0a342c because
it was included without proper signoffs from RTC maintainers.
parent 7735227e
...@@ -34,8 +34,7 @@ ...@@ -34,8 +34,7 @@
* Board-specific wiring options include using split power mode with * Board-specific wiring options include using split power mode with
* RTC_OFF_NOFF used as the reset signal (so the RTC won't be reset), * RTC_OFF_NOFF used as the reset signal (so the RTC won't be reset),
* and wiring RTC_WAKE_INT (so the RTC alarm can wake the system from * and wiring RTC_WAKE_INT (so the RTC alarm can wake the system from
* low power modes) for OMAP1 boards (OMAP-L138 has this built into * low power modes). See the BOARD-SPECIFIC CUSTOMIZATION comment.
* the SoC). See the BOARD-SPECIFIC CUSTOMIZATION comment.
*/ */
#define OMAP_RTC_BASE 0xfffb4800 #define OMAP_RTC_BASE 0xfffb4800
...@@ -402,17 +401,16 @@ static int __init omap_rtc_probe(struct platform_device *pdev) ...@@ -402,17 +401,16 @@ static int __init omap_rtc_probe(struct platform_device *pdev)
/* BOARD-SPECIFIC CUSTOMIZATION CAN GO HERE: /* BOARD-SPECIFIC CUSTOMIZATION CAN GO HERE:
* *
* - Device wake-up capability setting should come through chip * - Boards wired so that RTC_WAKE_INT does something, and muxed
* init logic. OMAP1 boards should initialize the "wakeup capable" * right (W13_1610_RTC_WAKE_INT is the default after chip reset),
* flag in the platform device if the board is wired right for * should initialize the device wakeup flag appropriately.
* being woken up by RTC alarm. For OMAP-L138, this capability
* is built into the SoC by the "Deep Sleep" capability.
* *
* - Boards wired so RTC_ON_nOFF is used as the reset signal, * - Boards wired so RTC_ON_nOFF is used as the reset signal,
* rather than nPWRON_RESET, should forcibly enable split * rather than nPWRON_RESET, should forcibly enable split
* power mode. (Some chip errata report that RTC_CTRL_SPLIT * power mode. (Some chip errata report that RTC_CTRL_SPLIT
* is write-only, and always reads as zero...) * is write-only, and always reads as zero...)
*/ */
device_init_wakeup(&pdev->dev, 0);
if (new_ctrl & (u8) OMAP_RTC_CTRL_SPLIT) if (new_ctrl & (u8) OMAP_RTC_CTRL_SPLIT)
pr_info("%s: split power mode\n", pdev->name); pr_info("%s: split power mode\n", pdev->name);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment