Commit 2107fb8b authored by Steve Glendinning's avatar Steve Glendinning Committed by David S. Miller

smsc911x: add dynamic bus configuration

Convert the driver to select 16-bit or 32-bit bus access at runtime,
at a small performance cost.
Signed-off-by: default avatarSteve Glendinning <steve.glendinning@smsc.com>
Acked-by: default avatarCatalin Marinas <catalin.marinas@arm.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 6fabd715
......@@ -77,19 +77,16 @@ struct smsc911x_data {
unsigned int generation;
/* device configuration (copied from platform_data during probe) */
unsigned int irq_polarity;
unsigned int irq_type;
phy_interface_t phy_interface;
struct smsc911x_platform_config config;
/* This needs to be acquired before calling any of below:
* smsc911x_mac_read(), smsc911x_mac_write()
*/
spinlock_t mac_lock;
#if (!SMSC_CAN_USE_32BIT)
/* spinlock to ensure 16-bit accesses are serialised */
/* spinlock to ensure 16-bit accesses are serialised.
* unused with a 32-bit bus */
spinlock_t dev_lock;
#endif
struct phy_device *phy_dev;
struct mii_bus *mii_bus;
......@@ -121,70 +118,56 @@ struct smsc911x_data {
unsigned int hashlo;
};
#if SMSC_CAN_USE_32BIT
static inline u32 smsc911x_reg_read(struct smsc911x_data *pdata, u32 reg)
{
return readl(pdata->ioaddr + reg);
}
static inline void smsc911x_reg_write(struct smsc911x_data *pdata, u32 reg,
u32 val)
{
writel(val, pdata->ioaddr + reg);
}
/* Writes a packet to the TX_DATA_FIFO */
static inline void
smsc911x_tx_writefifo(struct smsc911x_data *pdata, unsigned int *buf,
unsigned int wordcount)
{
writesl(pdata->ioaddr + TX_DATA_FIFO, buf, wordcount);
}
/* Reads a packet out of the RX_DATA_FIFO */
static inline void
smsc911x_rx_readfifo(struct smsc911x_data *pdata, unsigned int *buf,
unsigned int wordcount)
{
readsl(pdata->ioaddr + RX_DATA_FIFO, buf, wordcount);
}
#else /* SMSC_CAN_USE_32BIT */
/* These 16-bit access functions are significantly slower, due to the locking
/* The 16-bit access functions are significantly slower, due to the locking
* necessary. If your bus hardware can be configured to do this for you
* (in response to a single 32-bit operation from software), you should use
* the 32-bit access functions instead. */
static inline u32 smsc911x_reg_read(struct smsc911x_data *pdata, u32 reg)
{
unsigned long flags;
u32 data;
/* these two 16-bit reads must be performed consecutively, so must
* not be interrupted by our own ISR (which would start another
* read operation) */
spin_lock_irqsave(&pdata->dev_lock, flags);
data = ((readw(pdata->ioaddr + reg) & 0xFFFF) |
((readw(pdata->ioaddr + reg + 2) & 0xFFFF) << 16));
spin_unlock_irqrestore(&pdata->dev_lock, flags);
if (pdata->config.flags & SMSC911X_USE_32BIT)
return readl(pdata->ioaddr + reg);
if (pdata->config.flags & SMSC911X_USE_16BIT) {
u32 data;
unsigned long flags;
/* these two 16-bit reads must be performed consecutively, so
* must not be interrupted by our own ISR (which would start
* another read operation) */
spin_lock_irqsave(&pdata->dev_lock, flags);
data = ((readw(pdata->ioaddr + reg) & 0xFFFF) |
((readw(pdata->ioaddr + reg + 2) & 0xFFFF) << 16));
spin_unlock_irqrestore(&pdata->dev_lock, flags);
return data;
}
return data;
BUG();
}
static inline void smsc911x_reg_write(struct smsc911x_data *pdata, u32 reg,
u32 val)
{
unsigned long flags;
if (pdata->config.flags & SMSC911X_USE_32BIT) {
writel(val, pdata->ioaddr + reg);
return;
}
if (pdata->config.flags & SMSC911X_USE_16BIT) {
unsigned long flags;
/* these two 16-bit writes must be performed consecutively, so
* must not be interrupted by our own ISR (which would start
* another read operation) */
spin_lock_irqsave(&pdata->dev_lock, flags);
writew(val & 0xFFFF, pdata->ioaddr + reg);
writew((val >> 16) & 0xFFFF, pdata->ioaddr + reg + 2);
spin_unlock_irqrestore(&pdata->dev_lock, flags);
return;
}
/* these two 16-bit writes must be performed consecutively, so must
* not be interrupted by our own ISR (which would start another
* read operation) */
spin_lock_irqsave(&pdata->dev_lock, flags);
writew(val & 0xFFFF, pdata->ioaddr + reg);
writew((val >> 16) & 0xFFFF, pdata->ioaddr + reg + 2);
spin_unlock_irqrestore(&pdata->dev_lock, flags);
BUG();
}
/* Writes a packet to the TX_DATA_FIFO */
......@@ -192,8 +175,18 @@ static inline void
smsc911x_tx_writefifo(struct smsc911x_data *pdata, unsigned int *buf,
unsigned int wordcount)
{
while (wordcount--)
smsc911x_reg_write(pdata, TX_DATA_FIFO, *buf++);
if (pdata->config.flags & SMSC911X_USE_32BIT) {
writesl(pdata->ioaddr + TX_DATA_FIFO, buf, wordcount);
return;
}
if (pdata->config.flags & SMSC911X_USE_16BIT) {
while (wordcount--)
smsc911x_reg_write(pdata, TX_DATA_FIFO, *buf++);
return;
}
BUG();
}
/* Reads a packet out of the RX_DATA_FIFO */
......@@ -201,11 +194,19 @@ static inline void
smsc911x_rx_readfifo(struct smsc911x_data *pdata, unsigned int *buf,
unsigned int wordcount)
{
while (wordcount--)
*buf++ = smsc911x_reg_read(pdata, RX_DATA_FIFO);
}
if (pdata->config.flags & SMSC911X_USE_32BIT) {
readsl(pdata->ioaddr + RX_DATA_FIFO, buf, wordcount);
return;
}
#endif /* SMSC_CAN_USE_32BIT */
if (pdata->config.flags & SMSC911X_USE_16BIT) {
while (wordcount--)
*buf++ = smsc911x_reg_read(pdata, RX_DATA_FIFO);
return;
}
BUG();
}
/* waits for MAC not busy, with timeout. Only called by smsc911x_mac_read
* and smsc911x_mac_write, so assumes mac_lock is held */
......@@ -790,7 +791,7 @@ static int smsc911x_mii_probe(struct net_device *dev)
}
phydev = phy_connect(dev, phydev->dev.bus_id,
&smsc911x_phy_adjust_link, 0, pdata->phy_interface);
&smsc911x_phy_adjust_link, 0, pdata->config.phy_interface);
if (IS_ERR(phydev)) {
pr_err("%s: Could not attach to PHY\n", dev->name);
......@@ -1205,14 +1206,14 @@ static int smsc911x_open(struct net_device *dev)
/* Set interrupt deassertion to 100uS */
intcfg = ((10 << 24) | INT_CFG_IRQ_EN_);
if (pdata->irq_polarity) {
if (pdata->config.irq_polarity) {
SMSC_TRACE(IFUP, "irq polarity: active high");
intcfg |= INT_CFG_IRQ_POL_;
} else {
SMSC_TRACE(IFUP, "irq polarity: active low");
}
if (pdata->irq_type) {
if (pdata->config.irq_type) {
SMSC_TRACE(IFUP, "irq type: push-pull");
intcfg |= INT_CFG_IRQ_TYPE_;
} else {
......@@ -1767,9 +1768,7 @@ static int __devinit smsc911x_init(struct net_device *dev)
SMSC_TRACE(PROBE, "IRQ: %d", dev->irq);
SMSC_TRACE(PROBE, "PHY will be autodetected.");
#if (!SMSC_CAN_USE_32BIT)
spin_lock_init(&pdata->dev_lock);
#endif
if (pdata->ioaddr == 0) {
SMSC_WARNING(PROBE, "pdata->ioaddr: 0x00000000");
......@@ -1910,6 +1909,7 @@ static int __devinit smsc911x_drv_probe(struct platform_device *pdev)
{
struct net_device *dev;
struct smsc911x_data *pdata;
struct smsc911x_platform_config *config = pdev->dev.platform_data;
struct resource *res;
unsigned int intcfg = 0;
int res_size;
......@@ -1918,6 +1918,13 @@ static int __devinit smsc911x_drv_probe(struct platform_device *pdev)
pr_info("%s: Driver version %s.\n", SMSC_CHIPNAME, SMSC_DRV_VERSION);
/* platform data specifies irq & dynamic bus configuration */
if (!pdev->dev.platform_data) {
pr_warning("%s: platform_data not provided\n", SMSC_CHIPNAME);
retval = -ENODEV;
goto out_0;
}
res = platform_get_resource_byname(pdev, IORESOURCE_MEM,
"smsc911x-memory");
if (!res)
......@@ -1949,15 +1956,8 @@ static int __devinit smsc911x_drv_probe(struct platform_device *pdev)
dev->irq = platform_get_irq(pdev, 0);
pdata->ioaddr = ioremap_nocache(res->start, res_size);
/* copy config parameters across if present, otherwise pdata
* defaults to zeros */
if (pdev->dev.platform_data) {
struct smsc911x_platform_config *config =
pdev->dev.platform_data;
pdata->irq_polarity = config->irq_polarity;
pdata->irq_type = config->irq_type;
pdata->phy_interface = config->phy_interface;
}
/* copy config parameters across to pdata */
memcpy(&pdata->config, config, sizeof(pdata->config));
pdata->dev = dev;
pdata->msg_enable = ((1 << debug) - 1);
......@@ -1974,10 +1974,10 @@ static int __devinit smsc911x_drv_probe(struct platform_device *pdev)
goto out_unmap_io_3;
/* configure irq polarity and type before connecting isr */
if (pdata->irq_polarity == SMSC911X_IRQ_POLARITY_ACTIVE_HIGH)
if (pdata->config.irq_polarity == SMSC911X_IRQ_POLARITY_ACTIVE_HIGH)
intcfg |= INT_CFG_IRQ_POL_;
if (pdata->irq_type == SMSC911X_IRQ_TYPE_PUSH_PULL)
if (pdata->config.irq_type == SMSC911X_IRQ_TYPE_PUSH_PULL)
intcfg |= INT_CFG_IRQ_TYPE_;
smsc911x_reg_write(pdata, INT_CFG, intcfg);
......
......@@ -21,7 +21,6 @@
#ifndef __SMSC911X_H__
#define __SMSC911X_H__
#define SMSC_CAN_USE_32BIT 1
#define TX_FIFO_LOW_THRESHOLD ((u32)1600)
#define SMSC911X_EEPROM_SIZE ((u32)7)
#define USE_DEBUG 0
......
......@@ -28,6 +28,7 @@
struct smsc911x_platform_config {
unsigned int irq_polarity;
unsigned int irq_type;
unsigned int flags;
phy_interface_t phy_interface;
};
......@@ -39,4 +40,8 @@ struct smsc911x_platform_config {
#define SMSC911X_IRQ_TYPE_OPEN_DRAIN 0
#define SMSC911X_IRQ_TYPE_PUSH_PULL 1
/* Constants for flags */
#define SMSC911X_USE_16BIT (BIT(0))
#define SMSC911X_USE_32BIT (BIT(1))
#endif /* __LINUX_SMSC911X_H__ */
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment