drm/i915: Install a fence register for fbc on g4x

To enable framebuffer compression on a g4x, we not only need the buffer
to tiled (X only), we also need to hold a fence register for the buffer.
Currently we only install a fence register for pre-i965s when setting up
the scanout buffer. Rather than adding some convoluted logic to
g4x_enable_fbc() to acquire a fence register, and perhaps to
g4x_disable_fbc() to release it again, we can extend the acquisition
during setup to all chipsets.
Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
Cc: Jesse Barnes <jbarnes@virtuousgeek.org>
Signed-off-by: Eric Anholt <eric@anholt.net>

drivers/gpu/drm/i915/intel_display.c

@@ -1260,9 +1260,11 @@ intel_pipe_set_base(struct drm_crtc *crtc, int x, int y,
 		return ret;
 	}
 
-	/* Pre-i965 needs to install a fence for tiled scan-out */
-	if (!IS_I965G(dev) &&
-	    obj_priv->fence_reg == I915_FENCE_REG_NONE &&
+	/* Install a fence for tiled scan-out. Pre-i965 always needs a fence,
+	 * whereas 965+ only requires a fence if using framebuffer compression.
+	 * For simplicity, we always install a fence as the cost is not that onerous.
+	 */
+	if (obj_priv->fence_reg == I915_FENCE_REG_NONE &&
 	    obj_priv->tiling_mode != I915_TILING_NONE) {
 		ret = i915_gem_object_get_fence_reg(obj);
 		if (ret != 0) {