[AVR32] Add nwait and tdf parameters to SMC configuration

Complete the SMC configuration code by adding nwait and tdf
parameter. After this change, we support the same parameters as the
hardware.
Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>

arch/avr32/mach-at32ap/hsmc.c

@@ -75,12 +75,35 @@ int smc_set_configuration(int cs, const struct smc_config *config)
 		return -EINVAL;
 	}
 
+	switch (config->nwait_mode) {
+	case 0:
+		mode |= HSMC_BF(EXNW_MODE, HSMC_EXNW_MODE_DISABLED);
+		break;
+	case 1:
+		mode |= HSMC_BF(EXNW_MODE, HSMC_EXNW_MODE_RESERVED);
+		break;
+	case 2:
+		mode |= HSMC_BF(EXNW_MODE, HSMC_EXNW_MODE_FROZEN);
+		break;
+	case 3:
+		mode |= HSMC_BF(EXNW_MODE, HSMC_EXNW_MODE_READY);
+		break;
+	default:
+		return -EINVAL;
+	}
+
+	if (config->tdf_cycles) {
+		mode |= HSMC_BF(TDF_CYCLES, config->tdf_cycles);
+	}
+
 	if (config->nrd_controlled)
 		mode |= HSMC_BIT(READ_MODE);
 	if (config->nwe_controlled)
 		mode |= HSMC_BIT(WRITE_MODE);
 	if (config->byte_write)
 		mode |= HSMC_BIT(BAT);
+	if (config->tdf_mode)
+		mode |= HSMC_BIT(TDF_MODE);
 
 	pr_debug("smc cs%d: setup/%08x pulse/%08x cycle/%08x mode/%08x\n",
 		 cs, setup, pulse, cycle, mode);

include/asm-avr32/arch-at32ap/smc.h

@@ -47,11 +47,33 @@ struct smc_config {
 	 */
 	unsigned int	nwe_controlled:1;
 
+	/*
+	 * 0: NWAIT is disabled
+	 * 1: Reserved
+	 * 2: NWAIT is frozen mode
+	 * 3: NWAIT in ready mode
+	 */
+	unsigned int	nwait_mode:2;
+
 	/*
 	 * 0: Byte select access type
 	 * 1: Byte write access type
 	 */
 	unsigned int	byte_write:1;
+
+	/*
+	 * Number of clock cycles before data is released after
+	 * the rising edge of the read controlling signal
+	 *
+	 * Total cycles from SMC is tdf_cycles + 1
+	 */
+	unsigned int	tdf_cycles:4;
+
+	/*
+	 * 0: TDF optimization disabled
+	 * 1: TDF optimization enabled
+	 */
+	unsigned int	tdf_mode:1;
 };
 
 extern int smc_set_configuration(int cs, const struct smc_config *config);