Commit 044c18c9 authored by David S. Miller's avatar David S. Miller
parents 3f2e8d9f 174b2496
......@@ -1615,7 +1615,7 @@ static int ath_tx_setup_buffer(struct ieee80211_hw *hw, struct ath_buf *bf,
bf->bf_frmlen -= padsize;
}
if (conf_is_ht(&hw->conf) && !is_pae(skb))
if (conf_is_ht(&hw->conf))
bf->bf_state.bf_type |= BUF_HT;
bf->bf_flags = setup_tx_flags(sc, skb, txctl->txq);
......@@ -1701,7 +1701,7 @@ static void ath_tx_start_dma(struct ath_softc *sc, struct ath_buf *bf,
goto tx_done;
}
if (tx_info->flags & IEEE80211_TX_CTL_AMPDU) {
if ((tx_info->flags & IEEE80211_TX_CTL_AMPDU) && !is_pae(skb)) {
/*
* Try aggregation if it's a unicast data frame
* and the destination is HT capable.
......
......@@ -115,6 +115,7 @@
#define B43_MMIO_TSF_2 0x636 /* core rev < 3 only */
#define B43_MMIO_TSF_3 0x638 /* core rev < 3 only */
#define B43_MMIO_RNG 0x65A
#define B43_MMIO_IFSSLOT 0x684 /* Interframe slot time */
#define B43_MMIO_IFSCTL 0x688 /* Interframe space control */
#define B43_MMIO_IFSCTL_USE_EDCF 0x0004
#define B43_MMIO_POWERUP_DELAY 0x6A8
......
......@@ -628,10 +628,17 @@ static void b43_upload_card_macaddress(struct b43_wldev *dev)
static void b43_set_slot_time(struct b43_wldev *dev, u16 slot_time)
{
/* slot_time is in usec. */
if (dev->phy.type != B43_PHYTYPE_G)
/* This test used to exit for all but a G PHY. */
if (b43_current_band(dev->wl) == IEEE80211_BAND_5GHZ)
return;
b43_write16(dev, 0x684, 510 + slot_time);
b43_shm_write16(dev, B43_SHM_SHARED, 0x0010, slot_time);
b43_write16(dev, B43_MMIO_IFSSLOT, 510 + slot_time);
/* Shared memory location 0x0010 is the slot time and should be
* set to slot_time; however, this register is initially 0 and changing
* the value adversely affects the transmit rate for BCM4311
* devices. Until this behavior is unterstood, delete this step
*
* b43_shm_write16(dev, B43_SHM_SHARED, 0x0010, slot_time);
*/
}
static void b43_short_slot_timing_enable(struct b43_wldev *dev)
......
......@@ -2744,6 +2744,7 @@ int iwl_mac_config(struct ieee80211_hw *hw, u32 changed)
if ((le16_to_cpu(priv->staging_rxon.channel) != ch))
priv->staging_rxon.flags = 0;
iwl_set_rxon_ht(priv, ht_conf);
iwl_set_rxon_channel(priv, conf->channel);
iwl_set_flags_for_band(priv, conf->channel->band);
......
......@@ -794,7 +794,7 @@ static int iwm_mlme_update_bss_table(struct iwm_priv *iwm, u8 *buf,
}
bss->bss = kzalloc(bss_len, GFP_KERNEL);
if (!bss) {
if (!bss->bss) {
kfree(bss);
IWM_ERR(iwm, "Couldn't allocate bss\n");
return -ENOMEM;
......
......@@ -65,6 +65,7 @@ static struct usb_device_id rtl8187_table[] __devinitdata = {
/* Sitecom */
{USB_DEVICE(0x0df6, 0x000d), .driver_info = DEVICE_RTL8187},
{USB_DEVICE(0x0df6, 0x0028), .driver_info = DEVICE_RTL8187B},
{USB_DEVICE(0x0df6, 0x0029), .driver_info = DEVICE_RTL8187B},
/* Sphairon Access Systems GmbH */
{USB_DEVICE(0x114B, 0x0150), .driver_info = DEVICE_RTL8187},
/* Dick Smith Electronics */
......
......@@ -494,8 +494,7 @@ static int ssb_devices_register(struct ssb_bus *bus)
#endif
break;
case SSB_BUSTYPE_SDIO:
#ifdef CONFIG_SSB_SDIO
sdev->irq = bus->host_sdio->dev.irq;
#ifdef CONFIG_SSB_SDIOHOST
dev->parent = &bus->host_sdio->dev;
#endif
break;
......
......@@ -647,7 +647,7 @@ static void ieee80211_rx_mgmt_probe_req(struct ieee80211_sub_if_data *sdata,
}
if (pos[1] != 0 &&
(pos[1] != ifibss->ssid_len ||
!memcmp(pos + 2, ifibss->ssid, ifibss->ssid_len))) {
memcmp(pos + 2, ifibss->ssid, ifibss->ssid_len))) {
/* Ignore ProbeReq for foreign SSID */
return;
}
......
......@@ -439,6 +439,16 @@ static int __ieee80211_start_scan(struct ieee80211_sub_if_data *sdata,
if (local->scan_req)
return -EBUSY;
if (req != local->int_scan_req &&
sdata->vif.type == NL80211_IFTYPE_STATION &&
!list_empty(&ifmgd->work_list)) {
/* actually wait for the work it's doing to finish/time out */
set_bit(IEEE80211_STA_REQ_SCAN, &ifmgd->request);
local->scan_req = req;
local->scan_sdata = sdata;
return 0;
}
if (local->ops->hw_scan) {
u8 *ies;
......@@ -463,14 +473,6 @@ static int __ieee80211_start_scan(struct ieee80211_sub_if_data *sdata,
local->scan_req = req;
local->scan_sdata = sdata;
if (req != local->int_scan_req &&
sdata->vif.type == NL80211_IFTYPE_STATION &&
!list_empty(&ifmgd->work_list)) {
/* actually wait for the work it's doing to finish/time out */
set_bit(IEEE80211_STA_REQ_SCAN, &ifmgd->request);
return 0;
}
if (local->ops->hw_scan)
__set_bit(SCAN_HW_SCANNING, &local->scanning);
else
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment