A tentative address is not considered "assigned to an interface"
in the traditional sense (RFC2462 Section 4).
Don't try to select such an address for the source address.
Signed-off-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>

If the link was not available when the interface was created,
run DAD for pending tentative addresses when the link becomes ready.
Signed-off-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>

NETDEV_UP might be sent even if the link attached to the interface was
not ready.  DAD does not make sense in such case, so we won't do so.
After interface
Signed-off-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>

Signed-off-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>

Signed-off-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>

When a spinlock debugging check hits, we print the CPU number as an
informational thing - but there is no guarantee that preemption is off
at that point - hence we should use raw_smp_processor_id().  Otherwise
DEBUG_PREEMPT will print a warning.

With this fix the warning goes away and only the spinlock-debugging info
is printed.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Now needs to include the type 1 functions ("direct") too.

Reported by Pavel Roskin <proski@gnu.org>
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

We must check for MAY_SATTR before setting acls, which includes checking
for read-only exports: the lower-level setxattr operation that
eventually sets the acl cannot check export-level restrictions.

Bug reported by Martin Walter <mawa@uni-freiburg.de>.
Signed-off-by: Andreas Gruenbacher <agruen@suse.de>
Acked-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

All the work was done to setup the file and maintain the file handles but
the access functions were zeroed out due to the #ifdef.  Removing the
#ifdef allows full access to all the parameters when CONFIG_MODULES=n.

akpm: put it back again, but use CONFIG_SYSFS instead.
Signed-off-by: Jason Wessel <jason.wessel@windriver.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

The overflow checking condition in lib/swiotlb.c was wrong.
It would first run a NULL pointer through virt_to_phys before
testing it. Since pci_map_sg overflow is not that uncommon
and causes data corruption (including broken file systems) when not
properly detected I think it's better to fix it in 2.6.15.

This affects x86-64 and IA64.
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Whenever ywrap scrolling is selected together with 180 degree screen
rotation, 2.6.15-rc6 and earlier versions are broken.  fb_pan_display()
expects non-negative yoffsets, but ud_update_start() calls it with
yoffsets down to -(yres - font height).  This patch transforms yoffset
to the correct range 0 ...  vyres-1.

Some obviously unneeded parentheses are removed, too.

Verified with cyblafb, should be applied before 2.6.15-final because it
does fix the framebuffer rotation code introduced early in the 2.6.15
release cycle.
Signed-off-by: Knut Petersen <Knut_Petersen@t-online.de>
Acked-by: Antonino Daplas <adaplas@pol.net>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Reported by: janis huang (Bugzilla Bug 5747)

Fix on oops in intelfb.  Not sure what's happening, looks like
dinfo->name pointer is invalidated after initialization.  Remove
intelfb_get_fix, it's not needed and move the majority of the code to
the initialization routine.
Signed-off-by: Antonino Daplas <adaplas@pol.net>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Fix intelfb trying to free a non-existent resource in its error path.
Signed-off-by: Antonino Daplas <adaplas@pol.net>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

The g5 thermal control for liquid cooled machines has a small bug, when
the temperatures gets too high, it boosts all fans to the max, but
incorrectly sets the liquids pump to the min instead of the max speed,
thus causing the overtemp condition not to clear and the machine to shut
down after a while. This fixes it to set the pumps to max speed instead.
This problem might explain some of the reports of random shutdowns that
some g5 users have been reporting in the past.

Many thanks to Marcus Rothe for spending a lot of time trying various
patches & sending log logs before I found out that typo. Note that
overtemp handling is still not perfect and the machine might still
shutdown, that patch should reduce if not eliminate such occcurences in
"normal" conditions with high load. I'll implement a better handling
with proper slowing down of the CPUs later.
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Paul Mackerras <paulus@samba.org>

The CPM2 interrupt handler does not return success to the IRQ subsystem, which
causes it to kill the IRQ line after 100,000 interrupts.
Signed-off-by: Edson Seabra <Edson.Seabra@cyclades.com>
Signed-off-by: Marcelo Tosatti <marcelo.tosatti@cyclades.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
Signed-off-by: Paul Mackerras <paulus@samba.org>

Since we don't restore the volatile registers in the syscall exit
path, we need to make sure we don't leak any potentially interesting
values from the kernel to userspace.  This was already the case for
all except r11.  This makes it use r11 for an MSR value, so r11 will
have an (uninteresting) MSR value in it on return to userspace.
Signed-off-by: Paul Mackerras <paulus@samba.org>

 When mixing -olock and -onolock mounts on the same client, we have to
 check that fl->fl_u.nfs_fl.owner is set before dereferencing it.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 gss_create_upcall() should not error just because rpc.gssd closed the
 pipe on its end. Instead, it should requeue the pending requests and then
 retry.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 Ensure we call unmap_mapping_range() and sync dirty pages to disk before
 doing an NFS direct write.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 If we get something like the following,
 [  125.300636]  [<c04086e1>] schedule_timeout+0x54/0xa5
 [  125.305931]  [<c040866e>] io_schedule_timeout+0x29/0x33
 [  125.311495]  [<c02880c4>] blk_congestion_wait+0x70/0x85
 [  125.317058]  [<c014136b>] throttle_vm_writeout+0x69/0x7d
 [  125.322720]  [<c014714d>] shrink_zone+0xe0/0xfa
 [  125.327560]  [<c01471d4>] shrink_caches+0x6d/0x6f
 [  125.332581]  [<c01472a6>] try_to_free_pages+0xd0/0x1b5
 [  125.338056]  [<c013fa4b>] __alloc_pages+0x135/0x2e8
 [  125.343258]  [<c03b74ad>] tcp_sendmsg+0xaa0/0xb78
 [  125.348281]  [<c03d4666>] inet_sendmsg+0x48/0x53
 [  125.353212]  [<c0388716>] sock_sendmsg+0xb8/0xd3
 [  125.358147]  [<c0388773>] kernel_sendmsg+0x42/0x4f
 [  125.363259]  [<c038bc00>] sock_no_sendpage+0x5e/0x77
 [  125.368556]  [<c03ee7af>] xs_tcp_send_request+0x2af/0x375
 then the socket is blocked until memory is reclaimed, and no
 progress can ever be made.

 Try to access the emergency pools by using GFP_ATOMIC.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

I had thought that keeping the reported tail level clearly different
from the module name was a good idea, but I've changed my mind.

'raid5' is better and probably less confusing than 'RAID-5'.
Signed-off-by: Neil Brown <neilb@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This is just a basic cleanup. No change in functionality.
Signed-off-by: Ben Collins <bcollins@ubuntu.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Skip the memory 0xb50 to 0x1000 during "ethtool -t" memory test.
Overwriting memory in this region can cause ASF problems.

Update version and release date.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

The tw32_f() function (register write with immediate read flush) can
hang when used on some registers to switch clock frequencies and
power. A new tw32_wait_f() is added for such registers with the
delay before the read and after the read.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Add some missing workarounds in tg3_set_power_state():

1. Workaround to prevent overdrawing current on 5714.

2. Do not power down 5700's PHY because of hw limitation.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Locate the pdev_peer for dual port 5714 NIC devices in addition to
5704 devices. The name is also changed to tg3_find_peer() from
tg3_find_5704_peer(). It is also necessary to call netdev_priv() to
get to the peer's private tg3 structure.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

On sparc and sparc64, the rtc driver doesn't compile with PCI support 
disabled.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: David S. Miller <davem@davemloft.net>

Make sctp_writeable() use sk_wmem_alloc rather than sk_wmem_queued to
determine the sndbuf space available. It also removes all the modifications
to sk_wmem_queued as it is not currently used in SCTP.
Signed-off-by: Neil Horman <nhorman@tuxdriver.com>
Signed-off-by: Sridhar Samudrala <sri@us.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

When we insert a new xfrm_state which potentially
subsumes an existing one, make sure all cached
bundles are flushed so that the new SA is used
immediately.
Signed-off-by: David S. Miller <davem@davemloft.net>

Patch from Nicolas Pitre

Strictly speaking, the NPTL kernel helpers are required for pre ARMv6
only.  They are available on ARMv6+ as well for obvious compatibility
reasons.  However there are cases where extra memory barriers are needed
when using an SMP ARMv6 machine but not on pre-ARMv6.

This patch adds a memory barrier kernel helper that glibc can use as
needed for pre-ARMv6 binaries to be forward compatible with an SMP
kernel on ARMv6, as well as the necessary dmb instructions to the
cmpxchg helper.
Signed-off-by: Nicolas Pitre <nico@cam.org>
Acked-by: Daniel Jacobowitz <dan@codesourcery.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>

The route expiration time is stored in rt6i_expires in jiffies.
The argument of rt6_route_add() for adding a route is not the
expiration time in jiffies nor in clock_t, but the lifetime
(or time left before expiration) in clock_t.

Because of the confusion, we sometimes saw several strange errors
(FAILs) in TAHI IPv6 Ready Logo Phase-2 Self Test.
The symptoms were analyzed by Mitsuru Chinen <CHINEN@jp.ibm.com>.
Signed-off-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: David S. Miller <davem@davemloft.net>