Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

Unused outside of initial bus probe scan.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

One thing this change pointed out was that we really should
pull the "get 'local-mac-address' property" logic into a helper
function all the network drivers can call.
Signed-off-by: David S. Miller <davem@davemloft.net>

Otherwise the in-kernel PROM device tree isn't built yet,
and therefore the present cpu bits don't get set properly.
Signed-off-by: David S. Miller <davem@davemloft.net>

On some sun4v systems, after netboot the ethernet controller and it's
DMA mappings can be left active.  The net result is that the kernel
can end up using memory the ethernet controller will continue to DMA
into, resulting in corruption.

To deal with this, we are more careful about importing IOMMU
translations which OBP has left in the IO-TLB.  If the mapping maps
into an area the firmware claimed was free and available memory for
the kernel to use, we demap instead of import that IOMMU entry.

This is going to cause the network chip to take a PCI master abort on
the next DMA it attempts, if it has been left going like this.  All
tests show that this is handled properly by the PCI layer and the e1000
drivers.
Signed-off-by: David S. Miller <davem@davemloft.net>

If we end up zero'ing out the size of one of the entries,
pop it out of the array completely because some code that
examines these things cannot handle a zero length element
properly.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

This encodes a common idiomatic coding pattern used when
dealing with integer properties.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

Allow them to be enabled with "pci=irq_verbose" on the
boot command line.
Signed-off-by: David S. Miller <davem@davemloft.net>

It can be pushed even further down, but this is a first step.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

The basic framework is based on the PowerPC OF code.

This code even tries to get the device addressing components
correct in the full path names.
Signed-off-by: David S. Miller <davem@davemloft.net>

In particular, move the IRQ probing out to sparc32/sparc64
arch specific code where it belongs.
Signed-off-by: David S. Miller <davem@davemloft.net>

Prevent possible null dereference due to misplaced ;
Signed-off-by: Dave Jones <davej@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

* 'upstream-linus' of master.kernel.org:/pub/scm/linux/kernel/git/jgarzik/libata-dev: (258 commits)
  [libata] conversion to new debug scheme, part 1 of $N
  [PATCH] libata: Add ata_scsi_dev_disabled
  [libata] Add host lock to struct ata_port
  [PATCH] libata: implement per-dev EH action mask eh_info->dev_action[]
  [PATCH] libata-dev: move the CDB-intr DMA blacklisting
  [PATCH] ahci: disable NCQ support on vt8251
  [libata] ahci: add JMicron PCI IDs
  [libata] sata_nv: add PCI IDs
  [libata] ahci: Add NVIDIA PCI IDs.
  [PATCH] libata: convert several bmdma-style controllers to new EH, take #3
  [PATCH] sata_via: convert to new EH, take #3
  [libata] sata_nv: s/spin_lock_irqsave/spin_lock/ in irq handler
  [PATCH] sata_nv: add hotplug support
  [PATCH] sata_nv: convert to new EH
  [PATCH] sata_nv: better irq handlers
  [PATCH] sata_nv: simplify constants
  [PATCH] sata_nv: kill struct nv_host_desc and nv_host
  [PATCH] sata_nv: kill not-working hotplug code
  [libata] Update docs to reflect current driver API
  [PATCH] libata: add host_set->next for legacy two host_sets case, take #3
  ...

arch/ia64/kernel/acpi.c got forgotten when include/acpi/actbl.h
got a cleanup.
Signed-off-by: Tony Luck <tony.luck@intel.com>

My bad.
Signed-off-by: Nicolas Pitre <nico@cam.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Update hypfs for dhowells API changes.

Cc: Pekka Enberg <penberg@cs.helsinki.fi>
Cc: Ingo Oeser <ioe-lkml@rameria.de>
Cc: Joern Engel <joern@wohnheim.fh-wedel.de>
Cc: Martin Schwidefsky <schwidefsky@de.ibm.com>
Cc: Michael Holzheu <holzheu@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

drivers/cpufreq/cpufreq_ondemand.c: In function 'do_dbs_timer':
drivers/cpufreq/cpufreq_ondemand.c:374: warning: implicit declaration of function 'lock_cpu_hotplug'
drivers/cpufreq/cpufreq_ondemand.c:381: warning: implicit declaration of function 'unlock_cpu_hotplug'
drivers/cpufreq/cpufreq_conservative.c: In function 'do_dbs_timer':
drivers/cpufreq/cpufreq_conservative.c:425: warning: implicit declaration of function 'lock_cpu_hotplug'
drivers/cpufreq/cpufreq_conservative.c:432: warning: implicit declaration of function 'unlock_cpu_hotplug'

Cc: Dave Jones <davej@codemonkey.org.uk>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Do a safer check for when to enable DMA. Currently we enable ISA DMA
for cases that do not need it, resulting in OOM conditions when ZONE_DMA
runs out of space.
Signed-off-by: Jens Axboe <axboe@suse.de>

They all duplicate macros to check for empty root and/or node, and
clearing a node. So put those in rbtree.h.
Signed-off-by: Jens Axboe <axboe@suse.de>

Otherwise we could be racing with truncate/mapping removal.

Problem found/fixed by Nick Piggin <npiggin@suse.de>, logic rewritten
by me.
Signed-off-by: Jens Axboe <axboe@suse.de>

- Remember to set ->last_sector so that the cfq_choose_req() logic
  works correctly.

- Remove redundant call to cfq_choose_req()
Signed-off-by: Jens Axboe <axboe@suse.de>

This is a collection of patches that greatly improve CFQ performance
in some circumstances.

- Change the idling logic to only kick in after a request is done and we
  are deciding what to do. Before the idling included the request service
  time, so it was hard to adjust. Now it's true think/idle time.

- Take advantage of TCQ/NCQ/queueing for seeky sync workloads, but keep
  it in control for sync and sequential (or close to) workloads.

- Expire queues immediately and move on to other busy queues, if we are
  not going to idle after the current one finishes.

- Don't rearm idle timer if there are no busy queues. Just leave the
  system idle.
Signed-off-by: Jens Axboe <axboe@suse.de>

Patch originally from Vasily Tarasov <vtaras@sw.ru>

If you set io-priority of process 1 using sys_ioprio_set system call by
another process 2 (like ionice do), then cfq_init_prio_data() function
sets priority of process 2 (current) on queue of process 1 and clears
the flag, that designates change of ioprio.  So the process  1 will work
like with priority of process 2.

I propose not to call cfq_init_prio_data() on io-priority change, but
only mark queue as queue with changed prority.  Every time when new
request comes cfq-scheduler checks for this flag and atomaticaly changes
priority of queue to new value.
Signed-off-by: Jens Axboe <axboe@suse.de>

Signed-off-by: Jens Axboe <axboe@suse.de>

This saves 8 bytes of data in 64-bit archs.
Signed-off-by: Jens Axboe <axboe@suse.de>

The IDE power management can just use the ->end_io_data member to store
it's data.
Signed-off-by: Jens Axboe <axboe@suse.de>

A process flag to indicate whether we are doing sync io is incredibly
ugly. It also causes performance problems when one does a lot of async
io and then proceeds to sync it. Part of the io will go out as async,
and the other part as sync. This causes a disconnect between the
previously submitted io and the synced io. For io schedulers such as CFQ,
this will cause us lost merges and suboptimal behaviour in scheduling.

Remove PF_SYNCWRITE completely from the fsync/msync paths, and let
the O_DIRECT path just directly indicate that the writes are sync
by using WRITE_SYNC instead.
Signed-off-by: Jens Axboe <axboe@suse.de>

We cannot update them if the user changes nr_requests, so don't
set it in the first place. The gains are pretty questionable as
well. The batching loss has been shown to decrease throughput.
Signed-off-by: Jens Axboe <axboe@suse.de>

We already drop the refcount in elevator_exit(), and as
we're setting 'e' to NULL, we'll never take that branch anyway.
Finally, as 'e' is a local var that isn't referenced afterwards,
setting it to NULL is pointless.
Signed-off-by: Dave Jones <davej@redhat.com>
Signed-off-by: Jens Axboe <axboe@suse.de>

Signed-off-by: Alexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Jens Axboe <axboe@suse.de>

The queue lock can be taken from interrupts so it must always be taken with
irq disabling primitives.  Some primitives already verify this.
blk_start_queue() is called under this lock, so interrupts must be
disabled.

Also document this requirement clearly in blk_init_queue(), where the queue
spinlock is set.
Signed-off-by: Paolo 'Blaisorblade' Giarrusso <blaisorblade@yahoo.it>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Jens Axboe <axboe@suse.de>

Use hlist instead of list_head for request hashtable in deadline-iosched
and as-iosched. It also can remove the flag to know hashed or unhashed.
Signed-off-by: Akinobu Mita <mita@miraclelinux.com>
Signed-off-by: Jens Axboe <axboe@suse.de>

 block/as-iosched.c       |   45 +++++++++++++++++++--------------------------
 block/deadline-iosched.c |   39 ++++++++++++++++-----------------------
 2 files changed, 35 insertions(+), 49 deletions(-)

* master.kernel.org:/pub/scm/linux/kernel/git/davem/net-2.6:
  [NET]: Require CAP_NET_ADMIN to create tuntap devices.
  [NET]: fix net-core kernel-doc
  [TCP]: Move inclusion of <linux/dmaengine.h> to correct place in <linux/tcp.h>
  [IPSEC]: Handle GSO packets
  [NET]: Added GSO toggle
  [NET]: Add software TSOv4
  [NET]: Add generic segmentation offload
  [NET]: Merge TSO/UFO fields in sk_buff
  [NET]: Prevent transmission after dev_deactivate
  [IPV6] ADDRCONF: Fix default source address selection without CONFIG_IPV6_PRIVACY
  [IPV6]: Fix source address selection.
  [NET]: Avoid allocating skb in skb_pad