Commit ea1465d6 authored by Sandeep Paulraj's avatar Sandeep Paulraj Committed by Kevin Hilman

davinci: dm365: add MMC/SD support

Signed-off-by: default avatarSandeep Paulraj <s-paulraj@ti.com>
Signed-off-by: default avatarKevin Hilman <khilman@deeprootsystems.com>
parent d50452a5
......@@ -31,6 +31,8 @@
#define DAVINCI_MMCSD0_BASE 0x01E10000
#define DM355_MMCSD0_BASE 0x01E11000
#define DM355_MMCSD1_BASE 0x01E00000
#define DM365_MMCSD0_BASE 0x01D11000
#define DM365_MMCSD1_BASE 0x01D00000
static struct resource i2c_resources[] = {
{
......@@ -154,9 +156,7 @@ void __init davinci_setup_mmc(int module, struct davinci_mmc_config *config)
*/
switch (module) {
case 1:
if (!cpu_is_davinci_dm355())
break;
if (cpu_is_davinci_dm355()) {
/* REVISIT we may not need all these pins if e.g. this
* is a hard-wired SDIO device...
*/
......@@ -166,6 +166,20 @@ void __init davinci_setup_mmc(int module, struct davinci_mmc_config *config)
davinci_cfg_reg(DM355_SD1_DATA1);
davinci_cfg_reg(DM355_SD1_DATA2);
davinci_cfg_reg(DM355_SD1_DATA3);
} else if (cpu_is_davinci_dm365()) {
void __iomem *pupdctl1 =
IO_ADDRESS(DAVINCI_SYSTEM_MODULE_BASE + 0x7c);
/* Configure pull down control */
__raw_writel((__raw_readl(pupdctl1) & ~0x400),
pupdctl1);
mmcsd1_resources[0].start = DM365_MMCSD1_BASE;
mmcsd1_resources[0].end = DM365_MMCSD1_BASE +
SZ_4K - 1;
mmcsd0_resources[2].start = IRQ_DM365_SDIOINT1;
} else
break;
pdev = &davinci_mmcsd1_device;
break;
......@@ -180,9 +194,12 @@ void __init davinci_setup_mmc(int module, struct davinci_mmc_config *config)
/* enable RX EDMA */
davinci_cfg_reg(DM355_EVT26_MMC0_RX);
}
else if (cpu_is_davinci_dm644x()) {
} else if (cpu_is_davinci_dm365()) {
mmcsd0_resources[0].start = DM365_MMCSD0_BASE;
mmcsd0_resources[0].end = DM365_MMCSD0_BASE +
SZ_4K - 1;
mmcsd0_resources[2].start = IRQ_DM365_SDIOINT0;
} else if (cpu_is_davinci_dm644x()) {
/* REVISIT: should this be in board-init code? */
void __iomem *base =
IO_ADDRESS(DAVINCI_SYSTEM_MODULE_BASE);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment