atmel_spi throughput improvement

Don't insert (undesirable) delays between consecutive words (DLYBCT) or when
activating chipselects (DLYBS).

Removing the between-word delays improves the performance of bulk transfers
(such as mtd_dataflash, m25p80, mmc_spi) significantly.  In one test, the
improvement was a factor of more than eight!

(The large DLYBCT value came from the legacy at91 SPI driver, and it's not
clear why it used such a huge value.)
Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

drivers/spi/atmel_spi.c

@@ -490,9 +490,14 @@ static int atmel_spi_setup(struct spi_device *spi)
 	if (!(spi->mode & SPI_CPHA))
 		csr |= SPI_BIT(NCPHA);
 
-	/* TODO: DLYBS and DLYBCT */
-	csr |= SPI_BF(DLYBS, 10);
-	csr |= SPI_BF(DLYBCT, 10);
+	/* DLYBS is mostly irrelevant since we manage chipselect using GPIOs.
+	 *
+	 * DLYBCT would add delays between words, slowing down transfers.
+	 * It could potentially be useful to cope with DMA bottlenecks, but
+	 * in those cases it's probably best to just use a lower bitrate.
+	 */
+	csr |= SPI_BF(DLYBS, 0);
+	csr |= SPI_BF(DLYBCT, 0);
 
 	/* chipselect must have been muxed as GPIO (e.g. in board setup) */
 	npcs_pin = (unsigned int)spi->controller_data;